Rainsoft Air Check - Triguard Assembly, Part #13190
*** Note: This is an Obsolete item, with NONE remaining in stock.Our recommendation would be to replace the entire Valve Head on the tank.
Lower cost valves,
Noting for older valves, a few accessories would also be needed to make the conversion, THE OLDER BRASS BODY VALVE NOW ( pre-2001 ),
and not the newer plastic body valve ( since around 2001 ),
THEN:You would also need:( 1 ) A new Brine Pickup Tube with Air Check ( our part # FP60002 )( 2 ) And one 3/8"c x 3/8"c Elbow ( # 58506NO ),( 3 ) A few feet of 3/8" brine tubing ( # 50PE38BLK ).These accessories are listed below the Valves, as related products.THEN you must select a "connection" for the Valve.Either a low cost plastic piping yoke ( 3/4" or 1" male piping threaded ends ) or stainless steel By Pass ( 3/4" or 1" female piping threaded ).( CAN BE SELECTED when Valve is added to the Cart... selecting your Tank diameter and "Piping Options" choice )
** One or the other must be included, as the Fleck 5600 valve can not be connect to the plumbing without yoke OR by pass.