Knowledge Base:  

You are here: Knowledge Base : leaking out drain hose
Page of 1
Fleck 2510 Valve to Tank Adapter Leak - O-rings to replace
Common o-rings that need replacing for the valve to tank connections are 19936 ( # 7 in diagram below ) https://www.softenerparts.com/ Seal_Base_Seal_Fleck_2510_p/ 3419936.htm and 18303 ( # 14 in dia
Autotrol Valve Leaking to Drain after Replacing Valve Discs
Question: After installing new flapper valve disc set in my Autotrol Valve, I checked the function before powering up timer. The valves all seemed to work. I then turned the water flow back on and ha
# 1 FAQ = High Water in Brine Tank - Problem -Softener does not remove the water from my salt tank or overflow
My softener does not remove the water from my salt tank when it regenerates. What should I check? 1. Make sure all the fittings are tight. Also check the tubing going to the salt tank for
Brine Draw Failure in Sears, GE Smart Water, North Star Systems, Whirlpool, Morton, Ecodyne, Ecopure and others
Causes of suction failure in order of importance and frequency: 1 ) Gasket under Nozzle Venturi is worn, cracked, or "dried out". 2 ) Seal Kit is failing at some critical area, and not sealing. Note:
Brine Suction problem with Fleck 5600 or similar Hankscraft Valve
If your Fleck 5600 ( or similar Hankscraft design) Valve is not drawing ( sucking in ) the salt water from your brine tank, then here is a list of things to check and information about Brine Suction F
Fleck Valves - LEAKS out the DRAIN HOSE
LEAKS out the DRAIN HOSE: Fleck valves use pistons and internal seals to control water flow through the control valve head. When water continuously flows out the drain hose, and the unit has fini
Fleck 2500 leak to drain - Reasons why valve is still leaking after replacing the Seals & Spacers ( 60021 )
Reasons why Fleck 2500 valve is still leaking after replacing the Seals & Spacers ( 60121 ). Look at the condition of the Teflon on the Main Piston ( 60900 ). see: http://www.softenerparts.com/Piston
Autotrol 155 or 255 High Water in Brine Tank - Problem No Suction or Overflowing
If an Autotrol Model 155 or Newer Model 255 ( since 1995 ) is not drawing the Salt Water out of the Brine tank, What should I check? 1. Make sure all the fittings are tight. The conn