Rebuild Kit Fleck 5600 and Hankscraft HS and HD series water softener application,
Our 56PSKit includes
Main Piston Assembly 60102-00 ( for water softeners ),
Seals and Spacers 60125,
Brine Valve Piston 60032
ALWAYS IN STOCK - Ships same day ( M - F before 4 p.m. EST )Over time the wear and tear on the Pistons and Seals can cause the Valve to become STUCK in the regeneration cycle.
Replacing these 3 assemblies will usually restore the softener valve to like new condition.
The Fleck Manual also recommends replacing the Injector Drain Module Orings listed below ( 3456IDMO ).
It is not normally necessary to replace the oring ( 13302 ) in the Brine Valve "hole".
Note there are 2 of these o-rings ( 13302 ),
and
Only ONE comes on the new Brine Valve Piston Assembly ( 60032 ).
If you want or feel you need this extra o-ring ( that goes in the hole ), then please order a 2nd one separately. And other less common reasons that it might be "binding", or still getting stuck after replacing the Piston and Seals.
If you have a Backwashing Only valve, that does not use a Brine Valve ( 60032 ), then you should order the Backwash Filter Piston and Seals for 5600 Backwash ONLY Valves
( 3456PSKITBACKWASH ). And we have a separate Kit for IRON FILTER Rebuild Fleck 5600 green sand application,
Our
3456PSKITIRONFILTER includes
Main Piston Assembly 60102-10 ( for units that draw potassium permanganate or chlorine ),
Seals and Spacers 60125,
Brine Valve Piston 60032
NOTE:
3456PSKIT will not work to rebuild the digital Fleck valves ( such as 5600 SE, SXT, 6600, 6700 or Proflo ) 