CW-190-1 Intermatic Timer Motor 24 volts 60 Hz used in Rainsoft and very old Fleck timer assemblies.
The letters and first three numbers are the identifier for these Intermatic Timer Motors. The number after the dash is usually a 1 or a 2, but is not important when making your replacement. So the CW190-1 and CW190-2 would be the same 24 volt motor.
*** Note: This is an Obsolete item, with NONE remaining in stock.Motor 24 Volt Intermatic Timer CW190-1 CW190-2 - What to do If this part is obsolete and no longer available?
Our recommendation would be to replace the entire Valve Head on the tank.
Lower cost valves,
Noting for older valves, a few accessories would also be needed to make the conversion, THE OLDER BRASS BODY VALVE NOW ( pre-2001 ),
and not the newer plastic body valve ( since around 2001 ),
THEN:You would also need:( 1 ) A new Brine Pickup Tube with Air Check ( our part # FP60002 )( 2 ) And one 3/8"c x 3/8"c Elbow ( # 58506NO ),( 3 ) A few feet of 3/8" brine tubing ( # 50PE38BLK ).These accessories are listed below the Valves, as related products.THEN you must select a "connection" for the Valve.Either a low cost plastic piping yoke ( 3/4" or 1" male piping threaded ends ) or stainless steel By Pass ( 3/4" or 1" female piping threaded ).( CAN BE SELECTED when Valve is added to the Cart... selecting your Tank diameter and "Piping Options" choice )
** One or the other must be included, as the Fleck 5600 valve can not be connect to the plumbing without yoke OR by pass.