Replaces old brass shut off float pick up assemblies.
Includes 3/8" connection, Shut Off, Float, Air Check inside a 4" Brine Well with brine well cap.
Air check built into the bottom of the assembly.
Comes Assembled inside 30"
x 4" Brine Well
This is the sized used for most residential Brine tanks that are 30" - 36" in height.
If your tank is 40", then you'll want the 36" tall version ( BW4036-474 )Clack's 474 Brine Safety Float Pickup Tube available in three heights ( 30", 36" or 46" ) and can replace most old brass type brine shut off assemblies.
Comes with 3/8" Elbow
* See: How to use Quick Connect Fitting
The Shut Off Float Rod extends down about 10" from the top ( or 13 inches from the bottom ).
The 9.5 (overall length)float assembly is designed to be used as a safety back-up floatand is attached by a pin.
This position is the 40% - 50% level of a residential size brine tank ( which are 30 - 36 inches tall ), but below any Overflow fitting you might have ( usually installed about the 75 - 80% height level of the brine tank ).Average Salt Amount Needed and Normal Water Level In Brine Tank
NOTE: Not Recommended for a Kinetico unit due to the constant pressure on the brine line of those systems.