Softenerparts.com

Seal Kit with INSTRUCTIONS for Sears, GE, North Star 7129716 replaces 7081756, 7092163 and 7134224
G.E. part # WS35X10005
Includes our diagram key nos 24 - 29 ( kit # 30 ) and silicone.

Note there is a LARGER SIZE ( not this common 3/4" size used by most ): The Larger 1" Version Seal Kit ( 7185487, WS35X10020 ) is a full 1" larger, so please check if you are not sure before ordering.

For Model Number Reference, as to whether yours is 3/4" or 1" Valve design, see the Service Manual Listings on our website,
SEARS - Kenmore
or
GE Smartwater
or
Whirlpool

If your Valve is not drawing brine, and you have replaced the Nozzle Venturi Gasket ( PN 7204362 ) or it looks good,
THEN the next most likely cause of the problem is worn out Seal Orings.
Replacing the Seal Kit is very easy.
Each oring only fits where it belows.

It is recommended to check the surface of the Rotor Disc also, and replace if scratched, or if your valve has been getting STUCK ( and causing your Motor to slip or strip internal gears in the motor ).

IN STOCK ** SHIPS IN 24 HOURS ** ARRIVES IN 2 - 5 Days Standard Shipping or 2 - 3 days Priority Mail.

Rebuilding Valve:
A scratched, worn, or warped Rotor Disc must be replaced.
Seal Kit ( 7129716 ) should always be replaced at the same time. And may be needed more often than any other part.
If motor ( 7285944, old 7133008 ) has been clicking, or getting stuck, it too should be replaced at the same time to restore valve to proper operation.

Check Gasket ( 7204362 ) under Venturi Disc when ever you have a problem with brine suction, as this Gasket can get brittle with age.

Click Here for : INSTRUCTIONS FOR ROTOR DISC SEAL KIT

Click Here for : BRINE DRAW FAILURE REASONS

Repair Parts

Accessories

A Seal Kit Sears, GE, North Star 7129716, 7092163, 7134224, WS35X10005

Related Products...