Replacement 3/8", 2 - 4 oz Float Assembly For Potassium Permanganate Feeders.
It is 14 1/2 inches tall. This design has been used for over 25 years.
Also used in some systems using chlorine in the 5 gallon Feeder Tank.
Assembly includes air check, adjustable float, 3/8" elbow, and everything you see in the photo.
Instructions for attaching tubing to float assembly:
- Remove old float assembly from feeder tank.
- Install new float assembly:
- Tubing, only, goes through the "wall" of the feeder tank.
- Then nut is slid over the tubing.
- Then the plastic "insert" is pushed into the end of the tubing ( center ).
- Then tubing is pushed into elbow.
- Nut is then tightened to the elbow.
NOTE: Be careful not to "cross thread". Instructions for attaching tubing to float assembly: Remove old float assembly from feeder tank. Install new float assembly Tubing, only, goes through the "wall" of the feeder tank.
Then nut is slid over the tubing.
Then the plastic "insert" is pushed into the end of the tubing ( center ).
Then tubing is pushed into elbow.
Nut is then tightened to the elbow.
NOTE: Be careful not to "cross thread". 