Please place Orders Online

Email Questions
support@softenerparts.com

Technical Support 7 days a week.




Knowledge Base:  
You are here: Knowledge Base > How to Fix It > Water Not Soft, what could be wrong?

Page of 1
# 1 FAQ = High Water in Brine Tank - Problem -Softener does not remove the water from my salt tank or overflow
My softener does not remove the water from my salt tank when it regenerates. What should I check? 1. Make sure all the fittings are tight. Also check the tubing going to the sa
Brine Failure on ONE Tank Only - 9000 / 9100 Twin Alternating Valve
If your system uses one the twin alternating control valves ( common models are Fleck 9000, 9100, 8500, TwinFlo 100E , and Fleck 9500 ), and the Brine Suction cycle is failing to draw up the Brine fro
How Long Until Water Feels Soft Again After Repair
It can take several regenerations, and the "using up" of the Hot Water to get the "feel" back. It is recommended that you manually have the system run extra regenerations and to drain the hot water
Sears and GE Smartwater - Water Not Soft - Distributor Oring problem and solution
Sears Kenmore, NorthStar, Mortons, Whirlpool, and GE Smartwater softeners use the same clamp to tank valve design since the early 1990s. And on occasion the distributor o-ring, that fits on the outsi