Please place Orders Online

Email Questions
support@softenerparts.com

Technical Support 7 days a week.




Knowledge Base:  
You are here: Knowledge Base > RO Filter -Trouble shooting
How often do we need to change the RO filters and membrane?
Last Updated: 11/23/2015

3 Stage RO Unit
Typical 3 Stage RO Unit.

* Change the prefilter and the postfilter every 6 - 12 months is recommended.

Recommendation is to change the 2 filters that are vertical every 6 - 12 months.
And we would recommend using ( 2 ) of the CTO 2 Carbon Block for both.
CTO carbon block.

And the recommended TFC membrane most people would use is the 25 gpd


But note it is not always necessary to change the horizonally mounted membrane, as the "membrane", can last 2 - 5 years in most applications.

Various membrane sizes ( GPD ) rates are available.
The physical dimensions are standard and will work in any non-proprietary unit
And the most common residential sizes are these:
25 gpd
36 gpd
50 gpd

Or "WaterShield 50" ( Water Shield 50 ) uses S1764RS membrane
And like the Microline, uses special filters, S7028 and S7025.

Membrane Rinsing Directions


It says: Element must be rinsed under pressure before being soaked or stored in water.
The reason being they are shipped with a "preservative" ( = Sodium Metasulfite ), which if not fully rinsed, may have a "laxative" effect if consumed.
Discard product water 2 hours minimum ( some directions that come with new units have increased this to 8 hours, or multiple draining the holding tank before using the water ) before using for drinking water or food-related products.

What does this mean in laymanís terms?

****
Either DRAIN your storage tank, and then let it FILL UP and then DRAIN again... and then okay to use the RO water after the 2nd time it fills up,
OR
just leave the RO Faucet OPEN for 2 hours.... the flow will be very slow, but that is normal.
After 2 hours, shut off Faucet and let the storage tank fill up ( over night or several hours at least ).
Then it will be okay to use.



Sediment Pre-filter ( first filter your water enters ) can be Sediment Only = Sediment 5 micron

Second Pre-filter is also the Post Filter when only 3 "stages" are used ( diagram is showing 4 "stages" ) and it can be GAC or CTO carbon block.
And the CTO Carbon Block is recommended for this "stage", as the 2nd filter under most units. This should always be a Carbon Filter and in most cases the Pre-filter ( 1st filter ) should also be a Carbon Filter ( REQUIRED to be a Carbon filter, if your water source is chlorinated ).
see: CTO 5 Micron Carbon Block

The INLINE Filter ( final stage or Post Carbon Filter in diagram below ) used on some, not all units and is typically the 10" and has 1/4" threaded openings. see: Sealed Carbon 5 micron In Line

If yours does NOT have this "stage", then do not order one.
NOTE: Some new models use special In Line filters with built in "quick connect" for use with 1/4" or 3/8" tubing, and cost more because the fittings are build in. Also, the average RO system only has 3 stages ( pre-filter, membrane, and post filter ), and the "Inline" post filter is not used ( nor required ).

How do we know when it's time to change the filters?>

* You don't know unless you waited too long.....
Prefilter clogs, and water production drops.
And if in chlorinated water source, the membrane can be damaged, if prefilter not changed soon enough.

Typical RO and Filters Housings,
4 Stage,


To SEE How To Install a typical Reverse Osmosis System


We recommend this fine YouTube video produced by Water2Buy.co.uk http://www.youtube.com/watch?v=2eBCggg_jaI

For basic filter change explained


We recommend this these videos on YouTube, http://www.youtube.com/watch?v=9_ZY0yHnejg

Or this longer more detailed video, https://www.youtube.com/watch?v=c3Ly2Zh3j2Q

For basic membrane change explained


We recommend this fine video on YouTube, http://www.youtube.com/watch?v=SHs-W0wJOZg


Comprehensive Changing and Sanitizing of the RO System explained


We recommend this fine video on YouTube, https://www.youtube.com/watch?v=-kF_80OsU-I

*** Cleaner used in the above Video =Sani-System Liquid Sanitizer



Please Rate the Usefulness of this Article

Comments:
 

Related Articles
 > Microline Filters S7125 and S7128 are Different Size - Proprietary
 > CTA Membrane Not Enough Water
 > Low water flow RO filters - Tank Pressure Problem
 > Microline CTA-14, CTA-14D Obsolete, but filters still available
 > How often do we need to change the Membrane in the RO?
 > Air in water after changing Filters in the RO?
 > Microline Filters S7025X and S7028X are Glued into Sump Housing
 > Fixing a Dripping Long Reach Faucet - Video
 > How to Use Standard and Quick Connect Fittings - Video