Replacement 3/8", 2 - 4 oz Float Assembly For Potassium Permanganate Feeders.
Also used in some systems using chlorine in the 5 gallon Feeder Tank.
Assembly includes air check, adjustable float, 3/8" elbow, and everything you see in the photo.

Instructions for attaching tubing to float assembly:

• Remove old float assembly from feeder tank.
• Install new float assembly:
• Tubing, only, goes through the "wall" of the feeder tank.
• Then nut is slid over the tubing.
• Then the plastic "insert" is pushed into the end of the tubing ( center ).
• Then tubing is pushed into elbow.
• Nut is then tightened to the elbow.

NOTE: Be careful not to "cross thread".

• Instructions for attaching tubing to float assembly:
  
  
• Remove old float assembly from feeder tank.
• Install new float assembly Tubing, only, goes through the "wall" of the feeder tank.
  
• Then nut is slid over the tubing.
  
• Then the plastic "insert" is pushed into the end of the tubing ( center ).
  
• Then tubing is pushed into elbow.
  
• Nut is then tightened to the elbow.
  
  
• NOTE: Be careful not to "cross thread".